TM 9-2320-365-34-2
15-2. CAB REPLACEMENT (CONT)
CAUTION
Do not allow cab latch to change position
while tightening screws. Failure to comply
may result in damage to equipment.
(23.1) Tighten two screws (20.1) to 34-44 lb-ft (44-60 N·m).
(24) Install locking arms (21), spacer (22), washer (23), and
cotter pin (24) on cab tilt cylinder mounting bolt (18).
(25) Raise cab (TM 9-2320-365-10).
(26) Remove cab support tool from engine rear lifting eye
(20).
15-48
Change 1
