TM 9-2320-365-34-2NOTEApproximate depth of thread engagement is0.375 in. (9.525 mm). If puller assembly willnot engage to this depth, continue to cutthreads until this depth is achieved.(27) Apply sealing compound on threaded stem of pullerassembly (16).(28) Install puller assembly (16) into injector sleeve (11).(29) Install reaction sleeve (17) and plate (18) over threadedstem of puller assembly (16).(30) Position thrust bearing (19) on plate (18).(31) Position washer (20) on thrust bearing (19).(32) Install nut (21) on threaded stem of puller assembly (16).CAUTIONStop pulling on injector sleeve when it pulls freefrom lower bore. Manually lift puller assemblyenough to center injector sleeve in upper borebefore using wrench to pull injector sleevethrough upper bore. Failure to center injectorsleeve in upper bore may result in damage tocylinder head or tool.NOTEUpper bore in cylinder head is small enough thatinjector sleeve must be pulled through that borealso.(33) Remove injector sleeve (11) from cylinder head (1).(34) Remove nut (21), washer (20), thrust bearing (19), plate(18), and reaction sleeve (17) from puller assembly (16).(35) Remove injector sleeve (11) from puller assembly (16).20-9
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
