TM 9-2320-365-34-220-3. CYLINDER HEAD REPAIR (CONT)NOTEIf injector sleeve can not be removed byhand, perform steps (36) through (39), usingrelease block.(36) Position release block (22) in vise. Tighten vise onlyenough to secure release block.(37) Position threaded (stem) end of lower pilot (10) inrelease block (22).(38) Install washer (12) and nut (13) on puller assembly (16).(39) Turn puller assembly (16) and separate tools frominjector sleeve (11).(40) Remove two plugs (23), preformed packings (24), andfreeze plug (25) from front end of cylinder head (1).Discard preformed packings and freeze plug.(41) Remove plug (26), preformed packing (27), and freezeplug (28) from rear end of cylinder head (1). Discardpreformed packing and freeze plug.20-10
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
