TM 9-2320-365-34-221-14. C6 CLUTCH HOUSING ASSEMBLY REPAIR (CONT)NOTEReplace any part that fails visual inspectionor size measurements requirements.(2) Inspect sleeve (1) for excessive wear.(3) Inspect bushing (2) for excessive wear. Maximum insidediameter is 1.424 in. (3.617 cm).(4) Inspect C6 drive hub (3) for pitting, damage, andindication of wear on splines.(5) Inspect C6 friction plates (4) for wear. Minimumthickness is 0.145 in. (3.638 mm). Maximum bend 0.016in. (0.406 mm), and measure oil groove depth (A),minimum oil groove depth is 0.008 in. (0.203 mm).(6) Inspect C6 reaction plates (5) for wear. Minimumthickness is 0.087 in. (2.210 mm). Maximum bend is0.016 in. (0.406 mm).(7) Inspect C6 piston (6) to C6 clutch housing (7) tanggroove wear. Maximum tang groove wear is 0.09 in.(0.22 cm).(8) Inspect C6 piston (6) for seal ring groove wear, burring,and broken tangs.(9) Inspect spring retainer (8) for missing and brokensprings.(10) Inspect C6 backing plate (9) for scoring and burring.Minimum thickness is 0.311 in. (0.789 cm). Maximumbend is 0.016 in. (0.040 cm).21-68
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business