TM 9-2320-365-34-2
NOTE
Perform steps (10) through (16) if rear weld
nuts are damaged.
(10) Measure and mark a line (7) half way 0.625 in. (15.6
mm) between two forward weld nuts (8).
(11) Measure and mark a line (9) 4.500 in. (112.5 mm) in
back from front weld nuts (8) on line (10).
(12) Drill a pilot hole at intersection of lines (9 and 10).
(13) Drill a 2 in. (49 mm) hole at pilot hole.
(14) Remove damaged weld nut (11).
NOTE
Steps (15) and (16) require the aid of an
assistant.
(15) Position screw (12) and self-locking nut (13) in cab
support (3).
(16) Tighten screw (12) to 42-52 lb-ft (57-71 N·m).
Change 1
15-45