(21) Remove spreader bar, cargo sling and rubber sheet from
Cab latch must be adjusted so that it rides
squarely on the latch support and does not
contact the welded area of the latch support.
Failure to comply may result in damage to
(21.1) Adjust cab latch (19.1) on latch supports (19.2).
Brace cab with cab support tool before
installing locking arm, spacer, washer,
and cotter pin on tilt cylinder mounting
Failure to comply may result in
serious injury or death to personnel.
(22) Raise cab enough to install cab support tool on engine
rear lifting eye (20) (TM 9-2320-365-10).
After cab is lowered on cab support tool,
return cab tilt selector knob to the RAISE
position for added safety.
comply may result in injury to personnel.
(23) Lower cab on cab support tool (TM 9-2320-365-10).