• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Installation - TM-9-2320-365-34-2_966
Follow-On Maintenance - TM-9-2320-365-34-2_968

/.5tonv1-2/TM-9-2320-365-34-2 M10787 Series 2-1/2-Ton 4x4 Light Medium Tactical Vehicle (LMTV) Manual
Page Navigation
  893    894    895    896    897  898  899    900    901    902    903  
TM 9-2320-365-34-2 20-5.   CRANKSHAFT AND MAIN BEARINGS REPLACEMENT/REPAIR (CONT) WARNING Crankshaft weighs 130 lbs (59 kgs).   Use appropriate lifting device to lift crankshaft. Failure to comply  may result in  injury to personnel or damage to equipment. NOTE Step (7) requires the aid of an assistant. (7)  Position  crankshaft  (4)  on  seven  main  bearings  (1)  in cylinder block (2). NOTE Note position of tabs on main bearings. (8)  Install   No.   6   crankshaft   main   bearing   cap   (3)   on corresponding journal of crankshaft (4). (9)  Repeat  Step  (8)  for  remaining  main  bearing  caps  on corresponding journals of crankshaft (4). (10)  Position 14 washers (5) and bolts (6) in seven crankshaft main bearing caps (3). NOTE When  tightening  bolts  for  rear  main  bearing, slide  cap  as  far  forward  as  it  will  go  (towards front   of   engine)   against   its   bolts   to   prevent interference  between  crankshaft  main  bearing cap and engine rear seal. (11)  Tighten seven bolts (6), on side with tabs, to 35-45 lb-ft (47-61 N·m). (12)  Tighten seven bolts (6), on side without tabs, to 35-45 lb- ft (47-61 N·m). (13)  Match mark each bolt (6) and crankshaft main bearing cap (3). 20-38







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.