TM 9-2320-365-10
Table 3-2. Troubleshooting (Cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
e. ELECTRICAL SYSTEM (CONT)
e51.
BLACKOUT MARKER LIGHTS DO NOT ILLUMINATE (CONT).
(d)
Position main light switch to SER DRIVE (para 2-21c).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-21c).
(g)
Install PDP cover (para 3-13b).
(h)
If blackout marker lights still do not illuminate, notify Unit Maintenance.
e51a.
FRONT HAZARD LIGHTS DO NOT ILLUMINATE.
Step 1. Check operation of front and rear turn signals (para 2-21c).
If front and rear turn signals do not illuminate, perform Electrical System Troubleshooting (e53.
Front and Rear hazard Lights Do Not Illuminate).
Step 2. Check operation of rear hazard lights (para 2-21c).
(a)
If rear hazard lights do not illuminate, perform Electrical System Troubleshooting (e53.
Front and Rear Hazard Lights Do Not Illuminate).
(b)
If front hazard lights do not illuminate, notify Unit Maintenance.
e52.
REAR HAZARD LIGHTS DO NOT ILLUMINATE.
Step 1. Check operation of all vehicle lights (para 2-21c).
If either light does not illuminate, notify Unit Maintenance.
Step 2. Check circuit breaker (CB71) in PDP to see if it is tripped.
(a)
Remove PDP cover (para 3-13a).
(b)
Position main light switch to OFF (para 2-21c).
(c)
If circuit breaker is tripped, push in to reset.
(d)
Position main light switch to SER DRIVE (para 2-21c).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-21c).
(g)
Install PDP cover (para 3-13b).
(h)
If rear hazard lights still do not illuminate, notify Unit Maintenance.
e53.
FRONT AND REAR HAZARD LIGHTS DO NOT ILLUMINATE.
Step 1. Check operation of front and rear turn signals (para 2-21c).
3-50
Change 1
