TM 9-2320-365-10
Table 3-2. Troubleshooting (Cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
e53.
FRONT AND REAR HAZARD LIGHTS DO NOT ILLUMINATE (CONT).
(a)
If front and rear turn signals do not illuminate, perform Electrical System Troubleshooting
(e54. Front and Rear Turn Signals Do Not Illuminate.
(b)
If left or right front turn signal does not illuminate, perform Electrical System Troubleshooting
(e55. Left Or Right Front Turn Signal Does Not Illuminate).
(c)
If turn signals illuminate, go to step 2 of this fault.
Step 2. Check circuit breakers (CB71 and CB74) in PDP to see if it is tripped.
(a)
Position main light switch to OFF (para 2-21c).
(b)
Remove PDP cover (para 3-13a).
(c)
Check circuit breakers (CB71 and CB74) to see if they are tripped.
(d)
If circuit breaks (CB71 and CB74) are tripped, push in to reset.
(e)
Install PDP cover (para 3-13b).
(f)
Position main light switch to SER DRIVE (para 2-21c).
(g)
Position hazard lights switch to on (para 2-21c).
(h)
If front and rear hazard lights still do not illuminate, notify Unit Maintenance.
(i)
Position hazard lights switch to OFF (para 2-21c).
(j)
Position main light switch to OFF (para 2-21c).
e54.
FRONT AND REAR TURN SIGNALS DO NOT ILLUMINATE.
Step 1. Check operation of all vehicle lights (para 2-21c).
If either light does not illuminate, notify Unit Maintenance.
Step 2. Check circuit breaker (CB74) in PDP to see if it is tripped.
(a)
Remove PDP cover (para 3-13a).
(b)
Position main light switch to OFF (para 2-21c).
(c)
If circuit breaker is tripped, push in to reset.
(d)
Position main light switch to SER DRIVE (para 2-21c).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-21c).
(g)
Install PDP cover (para 3-13b).
(h)
If front and rear turn signals still do not illuminate, notify Unit Maintenance.
Change 1
3-51
