Change 1 2-647TM 9-2320-365-34-1CAUTIONUse care when disconnecting wiring harnessconnectors. Failure to comply may result indamage to equipment.CONTINUITY TEST(1) Remove control valve module (para 7-10).(2) Disconnect internal wiring harnessconnector C3 from C3 pressure switchconnector.(3) Set multimeter to ohms.(4) Connect positive (+) probe of multimeterto internal wiring harness 31-pin connectorpin W.(5) Connect negative (-) probe of multimeterto internal wiring harness connector C3pin 3B and note reading on multimeter.(6) If continuity is not present, replacetransmission internal wiring harness(para 7-13).(7) Connect positive (+) probe of multimeterto internal wiring harness 31-pin connectorpin W.(8) Connect negative (-) probe of multimeterto all other pins in internal wiring harness31-pin connector and note reading onmultimeter.(9) Connect negative (-) probe of multimeterto ground and note reading on multimeter.(10) If continuity is present, transmissioninternal wiring harness is shorted; replacetransmission internal wiring harness(para 7-13).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
