TM 9-2320-365-34-2
3-22. INLET MANIFOLD REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Valve cover removed (TM 9-2320-365-20-2).
Air inlet elbow removed (para 3-20).
Inlet manifold cover removed (para 3-21).
Fuel ratio control tube removed (TM 9-2320-365-
20-3).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-150 lb-in. (Item 79, Appendix B)
Tools and Special Tools (Cont)
Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B)
Socket, Socket Wrench (Item 55, Appendix B)
Wrench Set, Socket (Item 75, Appendix B)
Materials/Parts
Packing, Preformed (2) (Item 205, Appendix F)
Packing, Preformed (Item 191, Appendix F)
Gasket (Item 46, Appendix F)
Sealing Compound (Item 70, Appendix C)
a. Removal.
(1) Disconnect two ether start tubes (1) from ether start
nozzles (2).
(2) Remove two ether start nozzles (2) from adapters (3).
(3) Remove two adapters (3) from inlet manifold (4).
(4) Remove two preformed packings (5) from adapters (3).
Discard preformed packings.
(5) Remove fitting (6) from inlet manifold (4).
(6) Remove preformed packing (7) from fitting (6). Discard
preformed packing.
3-128
