TM 9-2320-365-34-2
6-3. STARTING MOTOR REPAIR (P/N M0017730MD) (CONT)
NOTE
Hold the shift housing end up for installation of
solenoid.
(37) Position starting motor solenoid (46) in shift housing (25).
(38) Rotate starting motor solenoid (46) so mounting bracket
is facing down.
WARNING
Adhesive
Sealant
MIL-S-46163
can
damage your eyes. Wear safety goggles
when using; avoid contact with eyes. If
sealant contacts eyes, flush eyes with
water
and
get
immediate
medical
attention. Failure to comply may result in
injury to personnel.
(39) Apply sealing compound to threads of two screws (47).
(40) Position two screws (47) in starting motor solenoid (46).
(41) Tighten two screws (47) to 20-24 lb-ft (27-32 N·m).
(42) Position strap (48) on starting motor solenoid terminal
(49) and starting motor terminal (50).
(43) Apply sealing compound to threads of starting motor
solenoid terminal (49) and starting motor terminal (50).
(44) Position nut (51) on starting motor terminal (50).
(45) Tighten nut (51) to 18-22 lb-ft (24-30 N·m).
(46) Position nut (52) on starting motor solenoid terminal (49).
(47) Tighten nut (52) to 21-29 lb-ft (28-39 N·m).
6-26
