TM 9-2320-365-34-2
(5) Inspect spring (4) for cracks, burrs, grooves, distortion,
scoring, excessive wear or varnish buildup.
(6) Inspect regulator valve (5) for cracks, burrs, grooves,
distortion, scoring, excessive wear or varnish buildup.
(7) Inspect two solenoids (6) for cracks, burrs, grooves,
distortion, scoring, excessive wear or varnish buildup.
(8) Measure resistance of two solenoids (6), resistance
should be between 2.0 - 5.0 ohms.
d. Assembly
WARNING
Use care when installing valve body
parts retained by retaining pins. Valve
body parts are under tension and can
act as projectiles when released. Failure
to comply may result in injury to
personnel.
CAUTION
Retaining pins must be installed from the
bottom. Failure to comply may result in
damage to equipment.
(1) Install preformed packings (1 and 2) on C6 interlock
valve solenoid (3).
(2) Install spring (4), C6 interlock valve (5) and C6
interlock valve solenoid (3) in C6 clutch valve body (6)
with retaining pin (7).
7-65
