TM 9-2320-365-34-2
7-10. CONTROL VALVE MODULE REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Front drive shaft removed (TM 9-2320-365-20-3).
Transmission oil filters removed (TM 9-2320-365-20-
3).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B)
Wrench, Torque, 0-150 lb-in. (Item 79, Appendix B)
Jack, Dolly Type, Hydraulic (Item 31, Appendix B)
Goggles, Industrial (Item 25, Appendix B)
Tools/Special Tools (Cont)
Wrench Set, Socket (Item 75, Appendix B)
Materials/Parts
Screw, Cap, Hex Head (3) (M10x1.5x55) (Item 77,
Appendix C)
Nut, Self-Locking (2) (Item 146, Appendix F)
Seal (Item 260, Appendix F)
Gasket (Item 36, Appendix F)
Lubricating Oil, Gear (Item 49, Appendix C)
Personnel Required
(2)
WARNING
• Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
• Ensure exhaust system is cool before
performing maintenance. Failure to comply
may result in injury to personnel.
a. Removal.
(1) Remove self-locking nut (1) from clamp (2). Discard
self-locking nut.
(2) Disconnect lower exhaust pipe (3) from muffler (4).
(3) Remove clamp (2) from lower exhaust pipe (3).
Change1
7-67
