TM 9-2320-365-34-2
NOTE
• Steps (27) and (28) require the aid of an
assistant.
• During installation of flexplate bolts, access
each flexplate bolt by turning alternator pulley
through a series of short arcs.
(27) Position 12 bolts (23) in flexplate (20).
NOTE
Perform step (28) on vehicles equipped
with transmission oil cooler tubes.
(28) Tighten 12 bolts (23) to 18-22 lb-ft (24-30 N·m).
NOTE
Perform step (29) on vehicles equipped
with transmission oil cooler hoses.
(29) Install gasket (24), flywheel cover (25), and
transmission oil cooler hose bracket (26) on flywheel
housing (22) with four washers (27) and screws (28).
(30) Position gasket (24), flywheel cover (25) on flywheel
housing (22) with four washers (28).
(31) Tighten four screws (26) to 21-25 lb-ft (30-35 N·m).
(32) Install seal (29) on oil fill tube (30).
(33) Install oil fill tube (30) in main housing module (31).
(34) Position oil fill tube clamp (32) on transmission (2) with
screw (33).
(35) Tighten screw (33) to 32-45 lb-ft (50-61 N·m).
(36) Position oil fill hose (34) on oil fill tube (30) and tube
(35) with two clamps (36).
(37) Tighten two clamps (36) to 24-48 lb-ft (3-5 N·m).
Change 1
7-121
