TM 9-2320-365-34-2
7-18. TRANSMISSION ASSEMBLY REPLACEMENT (UNUSUAL CONDITIONS) (CONT)
NOTE
Perform steps (38) through (40) on
transmission serial numbers prior to
6510032369.
(38) Remove bolt (37) from transmission (2).
(39) Position clamp (38) on transmission (2) with bolt (37).
(40) Tighten bolt (37) to 42-50 lb-ft (57-68 N·m).
(41) Install clamp (39) on transmission (2) with bolt (40)
and self-locking nut (41).
CAUTION
Due to position of main housing module
connector, extreme care must be taken
when installing pigtail adapter connector.
Failure to comply may result in damage to
equipment.
NOTE
• If transmission with serial number prior to
6510032369 was removed and replaced with
serial number 6510032369 and higher, a
transmission adapter harness (part number
29519210) will be used to adapt transmission
to transmission external wiring harness.
• Install plastic cable ties as required.
(42) Position transmission adapter harness (42) in main
housing module receptacle (43) with bolt (44).
(43) Tighten bolt (44) to 12-24 lb-ft (1-3 N·m).
7-122
Change 1
