TM 9-2320-365-34-2
7-18. TRANSMISSION ASSEMBLY REPLACEMENT (UNUSUAL CONDITIONS) (CONT)
(17) Position 12 washers (14) and bolts (15) in torque
converter housing module (16).
(18) Tighten 12 bolts (15) to 37-45 lb-ft (50-61 N·m).
NOTE
Perform steps (19) and (20) on vehicles
equipped with PTO.
(19) Position preformed packing (17) on 90-degree fitting
(17).
(20) Install 90-degree fitting (18) on transmission (2).
(21) Remove five bolts (8) and transmission lifting bracket
from adapter housing module (9).
(22) Position five bolts (8) in adapter housing module (9).
(23) Tighten five bolts (8) to 42-50 lb-ft (57-68 N·m).
NOTE
• Perform steps (22) through (24) on vehicle
serial numbers and higher.
• Steps (24) and (25) require the aid of an
assistant.
• During installation of flexplate bolts, access
each flexplate bolt by turning alternator pulley
through a series of short arcs.
(24) Position six bolts (19) in flexplate (20).
(25) Tighten six bolts (19) to 37-45 lb-ft (57-61 N·m).
(26) Install plug (21) in flywheel housing (22).
7-120
Change 1
