TM 9-2320-365-34-2
Section II. MAINTENANCE PROCEDURE
8-2. TRANSFER CASE CONTROL VALVE ASSEMBLY REPLACEMENT/REPAIR
This task covers:
a. Removal
b. Disassembly
c. Cleaning/Inspection
d. Assembly
e. Installation
f. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Batteries disconnected (TM 9-2320-365-20-3).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B)
Wrench, Torque, 0-150 lb-in (Item 79, Appendix B)
Goggles, Industrial (Item 25, Appendix B)
Gloves, Rubber (Item 23, Appendix B)
Multimeter, Digital (Item 34, Appendix B)
Wrench Set, Socket (Item 75, Appendix B)
Materials/Parts
Gasket (Item 41, Appendix F)
Gasket (Item 44, Appendix F)
Filter Element (Item 25, Appendix F)
Packing Preformed (Item 174, Appendix F)
Packing Preformed (Item 176, Appendix F)
Rag, Wiping (Item 59, Appendix C)
Dispenser, Pressure Sensitive Adhesive Tape
(Item 31, Appendix C)
Solvent, Dry Cleaning (Item 81, Appendix C)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. Removal.
(1) Remove 10 bolts (1), valve body cover (2), and gasket
(3) from transfer case module (4). Discard gasket.
8-2
Change 1
