TM 9-2320-365-34-2
8-3. TRANSFER CASE MODULE SEAL AND DRIVE YOKE REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Goggles, Industrial (Item 25, Appendix B)
Socket Set, Impact (Item 50, Appendix B)
Wrench, Impact, Electric (Item 77, Appendix B)
Socket, Socket Wrench (TM 9-2320-365-20)
Holding Bar, Pinion (TM 9-2320-365-20)
Installer, Seal (TM 9-2320-365-20)
Hammer, Hand, Soft Head (Item 28, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B)
Sling, Cargo (Item 48, Appendix B)
Tools and Special Tools (Cont)
Puller Kit, Universal (Item 44, Appendix B)
Puller, Mechanical (Item 45, Appendix B)
Materials/Parts
Grease, Automotive and Artillery (Item 36,
Appendix C)
Seal, Plain Encased (Item 265, Appendix F)
Nut, Self-Locking (Item 125, Appendix F)
Screw, Self-Locking (4) (Item 251.1, Appendix F)
Sealant (Item 64.1, Appendix C)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle. Falling debris may
cause eye injury. Failure to comply may
result in injury to personnel.
NOTE
Forward and rear seals and yokes are
replaced the same way. Rear seal and yoke
shown.
a. Removal.
(1) Remove four screws (1) and two bearing cups (2) from
drive yoke (3). Discard screws.
(2) Slide drive shaft (4) from side to side and separate
universal joint (5) from drive yoke (3).
NOTE
Step (3) requires the aid of an assistant.
(3) Attach drive shaft (4) to frame (6).
8-8
Change 1
