TM 9-2320-365-34-2
9-3. FRONT AXLE SHAFT AND SEALS REPLACEMENT (CONT)
(5) Install bushing (6), thrust washer (7), and seal (8) in
spindle assembly (9).
(6) Install spindle assembly (9) in steering knuckle (10).
NOTE
Step (7) requires the aid of an assistant.
(7) Position 10 screws (11), washers (12), and brake
assembly (13) on steering knuckle (10).
(8) Tighten 10 screws (11) to 110-145 lb-ft (149-197 N·m).
(9) Connect two brake hoses (14) to front brake air
chambers (15).
d. Follow-On Maintenance.
(1) Install wheel bearing/CTIS seal (TM 9-2320-365-20-3).
(2) Check oil level of front differential carrier (TM 9-2320-
365-20).
(3) Check oil level of hub assembly (TM 9-2320-365-20).
(4) Perform wheel toe-in adjustment (TM 9-2320-365-20-3).
(5) Start engine (TM 9-2320-365-10).
(6) Operate vehicle, checking for proper steering operation
and excessive vibration (TM 9-2320-365-10).
(7) Shut down engine (TM 9-2320-365-10).
(8) Check for oil leaks around wheel end assembly.
End of Task.
9-14
