TM 9-2320-365-34-2
10-2. REAR AXLE ASSEMBLY REPLACEMENT (CONT)
NOTE
Left and right side of U-bolts and mounting
pads are installed the same way. Left side
shown.
(11) Position rear axle assembly (1) under vehicle.
(12) Install two U-bolts (14) on rear leaf spring (15).
NOTE
Align hose on mounting pad with stud
protruding from bottom of leaf spring.
(13) Position mounting pad (16) on two U-bolts (14) with four
washers (17) and self-locking nuts (18).
(14) Tighten four self-locking nuts (18) to 200 lb-ft (271 N·m).
(15) Re-tighten four self-locking nuts (18) in increments of 50
lb-ft (271 N·m) to 390-510 lb-ft (529-692 N·m) in
sequence shown.
NOTE
Left and right side shock absorbers are
installed the same way. Right side shown.
(16) Position shock absorber (19) on rear axle assembly (1)
with bolt (20), two washers (21), and nut (22).
(17) Tighten nut (22) to 398-487 lb-ft (540-660 N·m).
(18) Remove transmission/differential lift from under vehicle.
(18.1) Perform steps (12) through (18) on left side of rear axle
assembly.
10-8
Change 1
