TM 9-2320-365-34-2
(18.2) Remove drive shaft (22.1) from frame (22.2).
WARNING
Do not use steel hammers to seat bearing
cups in drive yokes. Failure to comply may
result in injury to personnel or damage to
equipment.
CAUTION
Check bearing cups in ensure all needle
bearings are in place prior to installation.
replace bearing cups if needle are missing or
out of place. Failure to comply may result in
damage to equipment.
NOTE
Wipe end of yoke bearing bores prior to
installation.
(19) Position universal joint (23) on drive yoke (24) with two
bearing cups (25) and four screws (26).
NOTE
When correct torque is reached, bearing cap
screw small hex head will break off.
(20) Tighten four screws (26).
Change 1
10-8.1/(10-8.2 Blank)
