TM 9-2320-365-34-2
(6) Position five washers (4) and bolts (5) in rear axle
differential carrier (1).
(7) Tighten 12 bolts (5) to 74-96 lb-ft (100-130 N·m).
CAUTION
Ensure needle bearings are aligned prior to
installation of bearing cups on universal joint
end caps. Failure to comply may result in
damage to equipment.
NOTE
Step (8) requires the aid of an assistant.
(8) Remove drive shaft (6) from frame (7).
(9) Position universal joint (8) on drive yoke (9) with two
bearing cups (10) and four screws (11).
NOTE
When correct torque is reached, bearing cap
screw small hex head will break off.
(10) Tighten four screws (11).
Change 1
10-17
