TM 9-2320-365-34-211-2. AIR COMPRESSOR REPLACEMENT (CONT)(15) Connect ether sensor switch connector (21) to electricalconnector P-42 (22).(16) Connect connector clamp (23) on either sensor switchconnector (21).(17) Install clamp (24) on bracket (25) with screw (26),washer (27), and self-locking nut (28).WARNINGAdhesives, solvents, and sealing compoundscan burn easily, can give off harmful vapors,and are harmful to skin and clothing. Keepaway from open fire and use in a well-ventilated area. If adhesive, solvent, orsealing compound gets on skin or clothing,wash immediately with soap and water.Failure to comply may result in injury topersonnel.(17.1) Apply sealant to threads of bolt (31).(18) Position support bracket (29) on air compressor (1) withwasher (30) and bolt (31).(19) Position two washers (32) and bolts (33) in bracket (29).(20) Tighten bolt (31) to 28-38 lb-ft (38-52 N·m).(21) Tighten two bolts (33) to 25-31 lb-ft (35-43 N·m).(21.1) Tighten bolt (34) to 18-22 lb-ft (24-30 N·m).11-8 Change 1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
