TM 9-2320-365-34-2
Section II. MAINTENANCE PROCEDURES
12-2.
STEERING GEAR REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Cab raised (TM 9-2320-365-10).
Radiator removed (TM 9-2320-365-20-3)
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B)
Wrench Set, Socket (Item 74, Appendix B)
Vise, Machinists (Item 72, Appendix B)
Pan, Drain (Item 36, Appendix B)
Adapter, Socket Wrench (Item 2, Appendix B)
Puller, Mechanical (Item 45, Appendix B)
Tools and Special Tools (Cont)
Jack, Dolly Type, Hydraulic (Item 31, Appendix B)
Materials/Parts
Cap and Plug Set (Item 18, Appendix C)
Nut, Plain, Hex (Item 121, Appendix F)
Nut, Self-Locking (6) (Item 134, Appendix F)
Pin, Cotter (Item 227, Appendix F)
Dispenser, Pressure Sensitive Adhesive Tape
(Item 31, Appendix C)
Personnel Required
(2)
WARNING
Ensure engine is cool before performing
maintenance.
Failure to comply may
result in injury to personnel.
a. Removal.
CAUTION
Ensure steering axle wheels are pointed straight
ahead. Failure to comply may result in damage
to equipment.
Cap or plug hydraulic hoses and fittings to
prevent contamination of hydraulic system.
Failure to comply may result in damage to
equipment.
(1) Place drain pan under vehicle.
(2) Remove plug (1) and two metal ring seals (2) from
power steering return hose (3).
12-2
