TM 9-2320-365-34-2
Section II. MAINTENANCE PROCEDURES
14-2. FRONT LEAF SPRING REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Front drive shaft removed (left side) (TM 9-
2320-365-20-3).
Gravel deflector and gravel deflector
extension removed (TM 9-2320-365-20-3).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 80,
Appendix B)
Wrench, Torque, 0-200 lb-in. (Item 81,
Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 85,
Appendix B)
Jack, Dolly Type, Hydraulic (Item 31,
Appendix B)
Tools and Special Tools (Cont)
Trestles, Motor Vehicle Maintenance (2) (Item 71,
Appendix B)
Goggles, Industrial (Item 25, Appendix B)
Wrench Set, Socket (Item 74, Appendix B)
Socket, Left Front Leaf Spring U-Bolt (Item 8, Appendix D)
Materials/Parts
Nut, Self-Locking (4) (Item 124, Appendix F)
Pin, Cotter (Item 229, Appendix F)
Nut, Self-Locking (2) (Item 138, Appendix F)
Grease, Automotive and Artillery (Item 36, Appendix C)
U-bolt (Item 15.1, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. Removal.
(1) Deleted
(2) Deleted
(3) Remove wheel on side that leaf spring is being removed
(TM 9-2320-365-10).
14-2
Change 1
