TM 9-2320-365-34-2
(4) Position six washers (3) and screws (4) on bottom half
of differential carrier (2).
(5) Tighten 12 screws (4) to 74-96 lb-ft (100-130 N·m).
NOTE
Step (6) requires the aid of an assistant.
(6) Remove drive shaft (7) from leaf spring (8).
CAUTION
Ensure needle bearings are aligned prior to
installation of bearing cups on universal joint
end caps. Failure to comply may result in
damage to equipment.
(7) Position universal joint (9) on drive yoke (10) with two
bearing cups (11) and four screws (12).
NOTE
When correct torque is reached, bearing cap
screw small hex head will break off.
(8) Tighten four screws (12).
Change 1
9-17