13-9. REAR SPRING BRACKETS REPLACEMENT
This task covers:
Rear wheel removed (from side being replaced) (TM 9-
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B)
Wrench Set, Socket (Item 74, Appendix B)
Goggles, Industrial (Item 25, Appendix B)
Jack, Dolly Type, Hydraulic (Item 31, Appendix B)
Trestles, Motor Vehicle Maintenance (2) (Item 71,
Bolt (2) (Item 5, Appendix F)
Bolt (1) (Item 8, Appendix F)
Bolt (3) (Item 10, Appendix F)
Nut, Self-locking (6) (Item 134, Appendix F)
Nut, Self-locking (2) (Item 138, Appendix F)
Grease, Automotive and Artillery (GAA) (Item 36,
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
Left and right side rear spring brackets are
removed the same way. Right side shown.
Steps (1) through (8) require the aid of an
(1) Place two trestles under frame (1).
(2) Position floor jack under rear axle (2) and lift enough to
take weight off leaf spring (3).