TM 9-2320-365-34-2
4-7. FUEL CONTROL LINKAGE REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Rocker arm assemblies removed (para 3-12).
Tools and Special Tools
Tool Kit, Intl. Comb. Eng. (TM 9-2320-365-20)
Wrench, Torque, 0-150 lb-in. (Item 79,
Appendix B)
Tools and Special Tools (Cont)
Adapter, Socket Wrench, (Item 1, Appendix B)
Socket Wrench Attachment, Screwdriver (TM 9-2320-
365-20)
Hammer, Hand Soft Head (Item 28, Appendix B)
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench Set, Socket (Item 75, Appendix B)
Materials/Parts
Lubricating Oil, Engine (Item 46, Appendix C)
a. Removal.
(1) Remove clip (1) from adapter sleeve (2).
CAUTION
Do not use hard-jawed pliers or screwdriver
to move sleeve. Failure to comply may result
in damage to equipment.
(2) Slide adapter sleeve (2) in cylinder head (3).
WARNING
Use care when removing retaining rings.
Retaining rings are under tension and can
act as projectiles when released. Failure
to comply may result in injury to
personnel.
(3) Remove retaining ring (4) and clevis pin (5) from
governor linkage (6).
4-32
