TM 9-2320-365-34-2
4-9. FUEL GOVERNOR REPLACEMENT/REPAIR
This task covers:
a. Removal
b. Disassembly
c. Assembly
d. Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Cab raised (TM 9-2320-365-10).
Fuel shutoff solenoid removed (para 6-4).
Fuel ratio control tube removed (TM 9-2320-
365-20-3).
Governor linkage removed (TM 9-2320-365-20-
3).
Fuel setting checks performed (para 4-4).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Tool Kit, Auto Fuel and Electrical System
Repair (Item 65, Appendix B)
Wrench, Torque, 0-200 lb-in. (Item 81,
Appendix B)
Wrench Set, Socket (Item 75, Appendix B)
Tools and Special Tools (Cont)
Pliers, Slip Joint (Item 40, Appendix B)
Pan, Drain (Item 36, Appendix B)
Materials/Parts
Packing, Preformed (2) (Item 197, Appendix F)
Packing, Preformed (2) (Item 204, Appendix F)
Parts Kit, Engine Fuel Pump (Item 220, Appendix F)
Packing, Preformed (2) (Item 190, Appendix F)
Packing, Preformed (Item 199, Appendix F)
Gasket (Item 58, Appendix F)
Packing, Preformed (Item 189, Appendix F)
Packing, Preformed (2) (Item 191, Appendix F)
Personnel Required
(2)
a. Removal.
(1) Position drain pan under radiator draincock (1).
(2) Drain radiator (2) about halfway [approximately 15-20 qt
(14-19 L)].
(3) Disconnect fuel hose (3) from 90-degree fitting (4).
(4) Loosen hose clamp (5) on coolant hose (6).
(5) Disconnect coolant hose (6) from coolant tube
(7).
4-37
