TM 9-2320-365-34-2
(13) Measure lube regulator valve spring (11) for minimum
free length of 1.77 in. (4.5 cm).
(14) Measure main regulator valve spring (12) for minimum
free length of 3.88 in. (9.9 cm).
(15) Measure main control valve spring (13) for minimum
free length of 1.77 in. (4.5 cm).
(16) Measure C2 latch valve spring (14) for minimum free
length of 1.60 in. (4.1 cm).
(17) Measure exhaust back valve spring (15) for minimum
free length of 1.14 in. (2.9 cm).
(18) Measure C1 latch valve spring (16) for minimum free
length of 1.82 in. (4.6 cm).
(19) Measure converter regulator valve spring (17) for
minimum free length of 2.52 in. (6.4 cm).
c. Assembly.
WARNING
Use care when installing springs.
Springs are under tension and can act
as projectiles when released. Failure to
comply may result in injury to personnel.
(1) Position turbine speed sensor (1) on main valve body
(2) with two screws (3).
(2) Tighten two screws (3) to 9-10 lb-ft (12-14 N·m).
(3) Install control main valve (4), spring (5), stop (6), and
retaining pin (7) in main valve body (2).
7-85
