TM 9-2320-365-34-29-2. FRONT AXLE ASSEMBLY REPLACEMENT (CONT)(10) Position shock absorber (11) on front axle assembly (6)with bolt (12), washer (13), and nut (14).(11) Tighten nut (14) to 284-343 lb-ft (385-465 N·m).(12) Perform steps (5) through (11) on left side of front axleassembly.NOTEStep (12.1) requires the aid of an assistant.(12.1) Remove drive shaft (14.1) from crossmember (14.2).WARNINGDo not use steel hammers to seat bearing cups indrive yokes. Failure to comply may result in injury topersonnel or damage to equipment.CAUTIONCheck bearing cups to ensure all needlebearings are in place prior to installation.Replace bearing cups if needle bearings aremissing or out of place. Failure to comply mayresult in damage to equipment.NOTEWipe end of yoke bearing bores prior toinstallation.(13) Position universal joint (15) on drive yoke (16) with twobearing cups (17) and four screws (18).9-8 Change 1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
