TM 9-2320-365-34-2
NOTE
• Alternately tighten screws.
• When correct torque is reached, bearing cap
small screw hex head will break off.
(14) Tighten four screws (18).
(15) Connect drag link end (19) to pivoting arm (20).
(16) Position nut (21) on drag link end (19).
(17) Tighten nut (21) to 140-170 lb-ft (190-230 N·m).
(18) Install cotter pin (22) in nut (21).
NOTE
Left and right sides of front axle assembly is
installed the same way. Right side shown.
(19) Install clamp (23) on bracket (4) with screw (24) and self-
locking nut (25).
Change 1
9-8.1/(9-8.2 Blank)
