TM 9-2320-365-34-2
Section II. MAINTENANCE PROCEDURES
10-2. REAR AXLE ASSEMBLY REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Rear stabilizer bar removed (TM 9-2320-365-20-3).
Rear wheels removed (TM 9-2320-365-10).
Air tanks drained (TM 9-2320-365-10).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B)
Wrench Set, Socket (Item 74, Appendix B)
Lift, Transmission/Differential (Item 32, Appendix B)
Hammer, Hand, Soft Head (Item 28, Appendix B)
Jack, Leveling Support, Vehicle (TM 9-2320-365-20)
Tools and Special Tools (Cont)
Sling, Cargo (Item 48, Appendix B)
Materials/Parts
Dispenser, Pressure Sensitive Tape (Item 31,
Appendix C)
Nut, Self-locking (4) (Item 136, Appendix F)
Nut, Self-locking (8) (Item 124, Appendix F)
Screw, Self-locking (8) (Item 251.1, Appendix F)
U-bolt (4) (Item 15.1, Appendix F)
Personnel Required
(3)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. Removal.
(1) Place trestles under rear of vehicle.
(2) Disconnect axle breather tube (1) from 45-degree fitting
(2).
(3) Remove 45-degree fitting (2) from rear axle assembly
(3).
(4) Remove screw (4) from load spring (5).
Discard
lockwasher.
(5) Disconnect load spring (5) from rear axle assembly (3).
10-2
Change 1
