TM 9-2320-365-34-2
NOTE
• Left and right sides of rear axle assembly are
removed the same way. Left side shown.
• Tag hoses and connection points prior to
disconnecting.
(6) Remove hose (6) from 45-degree fitting (7).
(7) Remove hose (8) from tee fitting (9).
(8) Remove hose (10) from tee fitting (11).
(9) Remove hose (12) from tee fitting (13).
(10) Remove two self-locking nuts (14), four washers (15),
and two screws (16) from bracket (17). Discard self-
locking nuts.
(11) Separate bracket (17) from rear axle assembly (3).
(11.1) Perform steps (6) through (11) on right side of rear axle
assembly.
(12) Remove four screws (18) and two bearing cups (19)
from drive yoke (20). Discard screws.
(13) Slide drive shaft (21) from side to side and separate
universal joint (22) from drive yoke (20).
(13.1) Attach drive shaft (21) to frame (22.1).
Change 1
10-3
