TM 9-2320-365-34-2
13-18. FRAME MUFFLER SUPPORT BRACKET REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Muffler and heatshield removed (TM 9-2320-365-20-
3).
11K self-recovery winch (SRW) removed, if
equipped (para 16-2).
Angle bracket removed (RH side) (M1081) (para 13-
10).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-150 lb-in. (Item 79, Appendix B)
Tools and Special Tools (Cont)
Socket Set, Socket Wrench (Item 51, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B)
Goggles, Industrial (Item 25, Appendix B)
Wrench Set, Socket (Item 75, Appendix B)
Materials/Parts
Nut, Self-locking (Item 126, Appendix F)
Nut, Self-locking (2) (Item 139, Appendix F)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Removal.
NOTE
Front and rear frame muffler support brackets
are removed the same way. Front frame
muffler support bracket shown.
(1) Remove self-locking nut (1), screw (2), and clamp (3)
from frame muffler support bracket (4). Discard self-
locking nut.
(2) Remove two self-locking nuts (5), screws (6), and frame
muffler support bracket (4) from frame rail (7). Discard
self-locking nuts.
13-87
