TM 9-2320-365-34-2
15-3. CAB FRONT SUPPORT REPLACEMENT/REPAIR (CONT)
c. Assembly.
NOTE
Lubricate bushings with paraffin and mineral oil
prior to installation.
(1) Install bushing (1) in left side bearing housing (2).
(2) Install sleeve bushing (3) in bushing (1).
NOTE
Lubricate sleeve bushings with paraffin and
mineral oil prior to installation.
(3) Install sleeve bushing (4) in left side cab tilt arm (5).
WARNING
Adhesive Sealant MIL-S-46163 can damage
your eyes. Wear safety goggles when using;
avoid contact with eyes. Failure to comply
may result in injury to personnel. If sealant
contacts eyes, flush eyes with water and get
immediate medical attention.
Failure to
comply may result in injury to personnel.
(4) Apply adhesive sealant to threads on left side of cab
front support (6).
(5) Position left side bearing housing (2), washer (7), and
spanner nut (8) on cab front support (6).
(6) Tighten spanner nut (8) to 138-163 lb-ft (180-220 N·m).
(7) Perform steps (1) through (6) on right side of cab front
support assembly.
15-72
