TM 9-2320-365-34-2
WARNING
Standard cab weighs approximately 1400 lbs
(636 kgs). M1081 cab weighs approximately
1700 lbs (772 kgs). Attach a suitable lifting
device prior to installation.
Failure to
comply may result in serious injury or death
to personnel or damage to equipment.
CAUTION
Use spreader bar and place sheet rubber on
cargo sling to prevent damage to cab roof.
Failure to comply may result in damage to
equipment.
NOTE
Steps (11) through (23) require the aid of an
two assistants.
(11) Lower cab door windows and install cargo sling through
rear section of cab doors (23).
(12) Remove cab (24) from cab maintenance stand.
CAUTION
Lower cab straight down to clear radiator.
Failure to comply may result in damage to
equipment.
(13) Position cab (24) on two bearing housings (25).
WARNING
Adhesive
Sealant
MIL-S-46163
can
damage your eyes. Wear safety goggles
when using; avoid contact with eyes. If
sealant contacts eyes, flush eyes with
water
and
get
immediate
medical
attention. Failure to comply may result in
injury to personnel.
(14) Apply sealing compound to threads of two screws (26).
NOTE
Left and right side bearing housings are
installed the same way. Right side shown.
(15) Position two washers (27) and screws (26) in right side
bearing housing (25).
15-75
