TM 9-2320-365-34-2
15-3. CAB FRONT SUPPORT REPLACEMENT/REPAIR (CONT)
(26) Install pivot arm (4), spacer (34), washer (35), and cotter
pin (36) on cab tilt cylinder mounting bolt (31).
(27) Raise cab (TM 9-2320-365-10).
(28) Connect three pneumatic hoses (37) to 45-degree fittings
(38).
WARNING
Adhesive
Sealant
MIL-S-46163
can
damage your eyes. Wear safety goggles
when using; avoid contact with eyes. If
sealant contacts eyes, flush eyes with
water
and
get
immediate
medical
attention. Failure to comply may result in
injury to personnel.
(29) Apply sealing compound to threads of two screws (39).
(30) Position two screws (39) in left side bearing housing
(25).
(31) Tighten two screws (39) to 34-42 lb-ft (47-57 N·m).
(32) Perform steps (29) through (31) on right side bearing
housing.
(33) Position steering column universal joint (40) on steering
gear (41) with matchmarks aligned.
(34) Position screw (42) and self-locking nut (43) in steering
column universal joint (40).
(35) Tighten self-locking nut (43) to 31-39 lb-ft (43-53 N·m).
15-78
