TM 9-2320-365-34-2
16-6. POWER TAKEOFF (PTO) REPLACEMENT/REPAIR (CONT)
(2) Install two bearings (3) in input gear (4).
(3) Install two thrust washers (5) and input gear (4) in
housing (2).
(4) Install preformed packing (6) on idler shaft (7).
CAUTION
Ensure flat side of shaft is lined up to make
proper contact. Failure to comply may result in
damage to equipment.
(5) Install idler shaft (7) in housing (2).
NOTE
Perform steps (5.1) and (5.2) on PTO
Assembly (P/N 12378814-001).
(5.1) Install preformed packing (7.1) on plug (9).
(5.2) Position plug (9) in housing (2).
NOTE
Perform steps (6) and (7) on PTO Assembly
(P/N 276XMF-JX-D5XK).
(6) Install two preformed packings (8) on plug (9).
(7) Position washer (10) and plug (9) in housing (2).
(8) Tighten plug (9) to 97-106 lb-in. (11-16 N m).
CAUTION
Input gear should turn freely and have no
side-to-side movement. Failure to comply
may result in damage to equipment.
(9) Turn input gear (4) in housing (2).
16-36
Change 1
