TM 9-2320-365-34-2
(11) Verify wire (10) is not bent or broken.
d. Assembly.
NOTE
Apply lubricating oil to all parts during
assembly.
(1) Install needle bearing (1) in housing (2).
NOTE
Perform steps (1.1) through (1.4) on PTO
Assembly (P/N 12378814-001).
(1.1) Install two bearings (3) in input gear (4).
(1.2) Install two thrust washers (5) and input gear (4) in
housing (2).
(1.3) Install preformed packing (6) on idler shaft (7).
CAUTION
Ensure flat side of shaft is lined up to make
proper contact. Failure to comply may result
in damage to equipment.
(1.4) Install idler shaft (7) in housing (2).
Change 1
16-35
