TM 9-2320-365-34-2
NOTE
Transfer matchmarks to replacement parts
prior to installation.
(3) Position rotor (10) on shaft (11) with matchmarks
aligned.
(4) Position six washers (12) and self-locking nuts (13) on
shaft (11).
(5) Tighten six self-locking nuts (13) to 45 lb-in. (5 N·m).
WARNING
Use care when installing retaining rings.
Retaining rings are under tension and can
act as projectiles when released. Failure
to comply may result in injury to
personnel.
NOTE
Install retaining rings in positions noted
during removal.
(6) Install retaining ring (14) in front housing (15).
(7) Press bearing (16) in front housing (15).
(8) Install retaining ring (17) in front housing (15).
(9) Install shaft (11) in front housing (15).
Change 1
18-19
