TM 9-2320-365-34-2
3-11. FLYWHEEL HOUSING REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Starting motor removed (TM 9-2320-365-20-3).
Engine speed sensor removed (TM 9-2320-365-20-3).
Engine removed (para 3-3).
Flexplate removed (para 3-10).
Crankshaft rear seal removed (para 3-9).
Oil pan removed (para 3-16).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 80,
Appendix B)
Materials/Parts
Gasket Maker (Item 35.1, Appendix C)
Screw, Self-locking (10) (Item 253.1, Appendix
F)
Personnel Required
(2)
NOTE
Replacement flywheel housing will have a
plug on the right hand side.
a. Removal.
WARNING
Flywheel housing weighs approximately 75
lbs (34 kgs). Attach a suitable lifting device
prior to removal.
Failure to comply may
result in injury to personnel or damage to
equipment.
(1) Remove bolt (1) from flywheel housing (2).
(2) Remove two bolts (3) from flywheel housing (2).
NOTE
Step (3) requires the aid of an assistant.
(3) Remove 10 self-locking screws (4) and flywheel housing
(2) from engine (5). Discard self-locking screws.
Change 1
3-87
