TM 9-2320-365-34-2
c.
Assembly.
NOTE
Lubricate all grease seals, front and rear
spring caps, seals, and preformed packings
prior to installation.
(1)
Install grease seal (1) in clutch housing (2).
CAUTION
Ensure piston bearing is packed thoroughly
with grease. Failure to comply may result in
damage to equipment.
(1.1) Pack piston bearing (2.1) thoroughly with grease.
WARNING
Adhesives,
solvents,
and
sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. Keep away from open fire
and use in a well-ventilated area.
If
adhesive, solvent, or sealing compound
gets
on
skin
or
clothing,
wash
immediately with soap and water. Failure
to comply may result in injury to
personnel.
(1.2) Apply sealing compound to bearing surface of shaft (3).
(2) Install shaft (3) in shaft mount (4).
WARNING
Use care when installing retaining rings.
Retaining rings are under tension and can
act as projectiles when released. Failure
to comply may result in injury to
personnel.
(3) Install retaining ring (5) in shaft mount (4).
Change 1
5-5
