TM 9-2320-365-34-2c. Cleaning/Inspection.WARNINGDry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles andgloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and donot breathe vapors. Keep away from heat or flame. Never smoke when using solvent; theflashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F (50°C).Failure to comply may result in serious injury or death to personnel.If personnel become dizzy while using cleaning solvent, immediately get fresh air andmedical help. If Dry Cleaning Solvent contacts skin or clothes, flush with cold water. If drycleaning solvent contacts eyes, immediately flush eyes with water and get immediatemedical attention. Failure to comply may result in injury to personnel.(1) Clean all metal parts with dry cleaning solvent.NOTEReplace any part that fails visual inspection,size measurements requirements, orresistance checks.(2) Inspect rotating clutch valve body (1) for cracks, burrs,grooves, distortion, scoring, excessive wear, or varnishbuildup.(3) Inspect spring (2) for cracks, burrs, grooves, distortion,scoring, excessive wear, or varnish buildup.(4) Inspect regulator valve (3) for cracks, burrs, grooves,distortion, scoring, excessive wear, or varnish buildup.(5) Inspect solenoid (4) for cracks, burrs, grooves,distortion, scoring, excessive wear, or varnish buildup.(6) Perform resistance check on solenoid (4). Minimumresistance should be between 2.0 - 5.0 ohms on a 10ohm scale.7-59
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
