TM 9-2320-365-34-2
NOTE
Replace any part that fails visual inspection,
size measurements requirements, or
resistance checks.
(2) Inspect clutch valve body (1) for cracks, burrs,
grooves, distortion, scoring, excessive wear, or varnish
buildup.
(3) Measure resistance of three solenoids (2), resistance
should be between 2.0 - 5.0 ohms.
d. Assembly.
WARNING
Use care when installing valve body parts
retained by retaining pins. Valve body
parts are under tension and can act as
projectiles when released. Failure to
comply may result in injury to personnel.
CAUTION
Retaining pins must be installed from bottom
of solenoid body. Failure to comply may result
in damage to equipment.
(1) Install three preformed packings (1 and 2) on
solenoids (3).
(2) Install three springs (4), regulating valves (5),
solenoids (3), and retaining pins (6) in clutch valve
body (7).
7-55
