TM 9-2320-365-34-2
12-2.
STEERING GEAR REPLACEMENT (CONT)
(7) Place bracket (6) on steering gear assembly (1).
NOTE
Bolts installed in steps (8) and (9) are
different lengths. Position bolts in tagged
locations.
(8) Position three bolts (7) in bracket (6).
(9) Position bolt (8) in bracket (6).
(10) Tighten three bolts (7) and bolt (8) to 372-454 lb-ft (504-
616 N m).
WARNING
S t e e r i n g
g e a r
a s s e m b l y
w e i g h s
approximately 130 lbs (59 kgs).
Support
steering gear assembly on jack during
installation. Failure to comply may cause
injury to personnel or damage to equipment.
NOTE
Steps (11) through (15) require the aid of an
assistant.
(11) Remove steering gear assembly (1) from vise and place
on jack.
(12) Raise steering gear assembly (1) to mounting location.
NOTE
Bolts in steps (13) and (14) are different
lengths. Install bolts in holes marked during
removal.
(13) Position five bolts (9) and self-locking nuts (10) in
bracket (6).
(14) Position bolt (11) and self-locking nut (12) in bracket (6).
(15) Tighten five self-locking nuts (10) and self-locking nut
(12) to 232-284 lb-ft (315-385 N m) in sequence shown.
12-6
