TM 9-2320-365-34-212-3. STEERING GEAR ASSEMBLY ADJUSTMENT (CONT)(43) Turn steering wheel to right until stops are reached.(44) Check pressure reading on STE/ICE-R. Pressurereading should be between 500-1000 psi (3448-6895kPa).(45) Shut down engine (TM 9-2320-365-10).(46) Remove plastic cable ties and two steering stop shimgages from steering stop bolt (15).(47) Raise vehicle off trestles.(48) Remove two trestles from vehicle.(49) Lower vehicle to ground.(50) Start engine (TM 9-2320-365-10).(51) Turn steering wheel left until stops are reached andverify pressure increases and then decreases to a rangebetween 500-1000 psi (3448-6895 kPa).(52) Turn steering wheel right until stops are reached andverify pressure increases and then decreases to a rangebetween 500-1000 psi (3448-6895 kPa).NOTEIf pressure readings obtained in steps (51)and (52) are not within range, repeat steps(24) through (49).(53) Shut down engine (TM 9-2320-365-10).(54) Disconnect test cable (13) from DCA connector (14).(55) Raise cab (TM 9-2320-365-10).12-14
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
