TM 9-2320-365-34-2
12-3.
STEERING GEAR ASSEMBLY ADJUSTMENT
This task covers:
a. Adjustment
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B)
Trestle, Motor Vehicle Maintenance (2) (Item 71,
Appendix B)
Pan, Drain (Item 36, Appendix B)
STE/ICE-R (Item 60, Appendix B)
Crowfoot, Attachment (Item 14, Appendix B)
Gage, Steering Stop Shim (2) (Item 17, Appendix D)
Jack, Dolly Type Hydraulic (2) (Item 31, Appendix B)
Materials/Parts
Coupling, Pipe (Item 25, Appendix C)
Tee, Pipe to Tube (Item 86, Appendix C)
Lubricating Oil, Engine (Item 44, Appendix C)
Ties, Cable, Plastic (Item 89, Appendix C)
Personnel Required
(2)
References:
TM 9-4910-571-12 & P
a. Adjustment.
(1) Remove two screws (1) and washers (2) from front grille
(3).
(2) Remove screw (4), washer (5), and front grille (3) from
cab (6).
NOTE
Step (3) and (4) require the aid of an
assistant.
(3) Raise front axle (7) until wheels are off ground.
(4) Place two trestles under front axle (7).
12-9
