TM 9-2320-365-34-2
13-5. REAR TENSION BEAM AND TAILLIGHT MOUNTING BRACKET REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Taillight carriers removed (TM 9-2320-365-20-3).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B)
Wrench Set, Socket (Item 74, Appendix B)
Goggles, Industrial (Item 25, Appendix B)
Materials/Parts
Bolt (14) (Item 10, Appendix F) (M1078/M1079)
Nut, Self-locking (14) (Item 134, Appendix F)
Bolt (10) (Item 10, Appendix F) (M1081)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris.
Failure to
comply may result in injury to personnel.
a. Removal.
CAUTION
When removing bolts, continuous removal of
collars is mandatory. Failure to comply will
result in seizing of collar to bolt.
NOTE
• Left and right side of rear tension beam is
removed the same way. Left side shown.
• Steps (1) through (5) require the aid of an
assistant.
(1) Remove two collars (1) and bolts (2) from rear tension
beam (3). Discard collars and bolts.
Change 1
13-9
